Exposed edges on trailers and cabinets can wear down or look unfinished over time. This smooth C-channel trim covers raw edges to protect them and create a clean, finished edge along panels.
If you're replacing worn trim or finishing exposed panel edges, getting the right fit is important. This C-channel trim is not trailer-specific. To get the right fit, you'll need to match it to your existing trim by measurement. If you're replacing a section, measure your current trim or panel edge and compare:
The fit depends on both the channel opening and the panel thickness. Even small differences can prevent the panel from seating properly or staying securely in place. If you're not sure, take a few measurements and photos of your current setup and reach out to etrailer support for help comparing options.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steve here with etrailer.com. Let's take a look at our PNF Product C channel for enclosed trailers. Now folks this is a smooth aluminum construction, so you're not gonna have to worry about rust or corrosion. You can cut it to fit your specific needs and your specific product. And this is gonna measure 93 and 1/2 inches long, and it's gonna be one inch tall by one and 1/8 inches wide.
So again, folks conceal unfinished edges, whether it's a trailer doors, ramp flaps, or even cabinets with the C channel. So as you can see, it is aluminum. And again, it's about one inch tall overall by one and 1/8 inch deep or wide. And the overall length again is 93 and 1/2 inches long. Now I'm gonna try my best to spin this around if I can and show you the end of this.
Bear with my camera there. Okay, so as you can see that closeup there, a nice C channel, aluminum construction. And again, same thing. Whenever you get this, you're just gonna cut it to the length that you need and then put it on the product that you need it for. So, very simple to install, very simple to use.
You may have to drill some holes through it and use your own hardware to attach it at that point. But it's gonna be a great finished look and a great finished product for you. Folks, That will wrap it up for our quick look at this aluminum PNF product C channel. I'm Steven. Thanks for watching.
.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.